Step 1.
Obtain one of the Support Braces with threaded studs. Place it upside
down on the work surface with threads facing up (see photo 1). Obtain a Cross
Brace and flip this over as well as shown in Photo 1 below. Slide one of the ends
of the Cross Brace into the area below the countersunk holes on the Support
Brace. The countersunk holes of the Support Brace should line up with the
threaded holes of the Cross Brace.
Step 2.
Using the 5/32” T- wrench or ratchet wrench (supplied with stand)
attach the Cross Brace to the Support Brace with the 1/4” - 20 x 3/4” flat head
cap screws (also supplied with the unit). Before tightening screw fully be sure
that the Cross Brace and Support Brace are completely perpendicular to each
other as shown in Photo 2. Tighten screws (shown in Photo 3) until the screws
stop turning and the top of wrench handle twists an additional 1/16 and 1/8 of a
rotation relative to the bolt. This will give you proper torque on the assembly.
Repeat steps 1 and 2 for the opposite side of the Cross Brace with again checking
that the two parts are perpendicular to each other (minor adjustments can be
made prior to torque of the bolts).
Note: If assembling a double or triple wide SXR the Center Brace will be
installed to the other side of the Cross Brace.
Photo 1
