Measuring procedure
After the cuff has been appropriately positioned,the
measurement can begin:
1).Press the START/STOP button, all symbols appear on
the display , you can hear 2 short beep after 0 flash for 2
seconds, then the pump begins to inflate the cuff, the
rising pressure in the cuff is shown on the display.
2).After the suitable pressure has been reached,the
pump stops and the pressure gradually falls.The cuff
pressure is displayed.In case that the inflation is not
sufficient,the device automatically re-inflates to a higher
pressure.
3).When the device detects the signal, the heart
symbol on the display starts to flash, you can hear the
beep for every heartbeat once the heartbeat signal is
detected.
4). When the measurement has been completed, you
can hear a long beep, in the meantime, the
systolic,diastolic and pulse rate will appear on the
display.
5). The measurement readings remain on the display
until you switch off the device.If no button is pressed for
a period of 3 minutes, the device switches off itself in
order to save the power.
Proper use of the unit
14/25
Note:
Discontinuing a measurement
The symbol will be displayed along with the reading if the
irregular heartbeat is detected during the measurement.
If it is necessary to interrupt a blood pressure measurement for any
reason(eg.the patient feels unwell)the START/STOP button can be
pressed at any time.The device immediately decrease the cuff
pressure automatically.