VDPCRGB3
10.01.2011
©2009 Velleman nv
4
3.
General Guidelines
Refer to the
Velleman
®
Service and Quality Warranty
on the last
pages of this manual.
•
The
VDPCRGB3
should only be used indoors.
•
Protect this device from shocks and abuse. Avoid brute force when
operating the device.
•
Protect the device against extreme heat and dust.
•
Familiarise yourself with the functions of the device before actually
using it. Do not allow operation by unqualified people. Any damage
that may occur will most probably be due to unprofessional use of
the device.
•
Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
4.
Features
•
small intelligent 3 channel DMX controller for LED RGB strips
•
DMX or auto program selection via DIP switches
•
for use with: CHLR4RGB
5.
Overview and use
Refer to the illustrations on page
2
of this manual.
•
For wiring instructions, see table below.
Do not
plug the power
supply into the mains before all connections are made!
terminal connect
to
DC-
GND of power supply
DC+
positive pole of power supply
COM positive
pole of LED-strip
CH1
LED-strip channel 1
CH2
LED-strip channel 2
CH3
LED-strip channel 3
Notes:
1. Do not
use a 24VDC power supply to power 12VDC LED strips.
2. Never
connect the
COM
terminal to ground! It is internally
connected to the
DC+
terminal!
•
When using a DMX system, set the DMX address
(see
§6
) and plug in the DMX-cable
[B]
.
•
Connect a DMX cable to the DMX-output
[C]
to
continue the DMX line or terminate the chain with
a 120
Ω
resistor between pin 2 and 3.
•
Connect the power supply to the mains.