Cross Trainer - XTR4
6
BEFORE CONTINUING ASSEMBLY YOU MUST READ THE FOLLOWING
IMPORTANT INFORMATION.
PLEASE NOTE:
ANY DAMAGES TO THE BOLT OR PRODUCT CAUSED BY FAILURE TO FOLLOW THESE STEPS
BELOW MAY RENDER THE PRODUCT’S WARRANTY VOID.
IMPORTANT: THE LEFT HAND BOLT AND NUT (BLUE) IS A REVERSE THREAD (ANTI-CLOCKWISE).
The bolt has an L imprinted on the head. Be sure to
use the correct bolts (marked L or R) and the correct
nuts (Left-blue/Right-beige) on the appropriate side.
•
When installing, ensure the wave washer and spring
washer are correctly located
•
Tighten the bolt through the crank arm as pictured.
Ensure the wave washer pushes up hard against the
bolt head once installed.
•
Tighten the nut on the bolt until the spring washer is
flat against the crank. As it is a threaded nut, this will
require extra force.
FAILURE TO FOLLOW THE PROCEDURE EXACTLY
AS DESCRIBED MAY CAUSE DAMAGE TO THE BOLTS/CRANK/NUTS AND COULD VOID YOUR
WARRANTY.
In order to install the hinge bolt properly, keep it
perfectly straight as the bolt goes through the pedal
tubing and the crankshaft. If the hinge bolt is
connected to the crankshaft at an angle, damage to
both the hinge bolt and the crankshaft may occur.
