HPE Aruba AP-MNT-W4 Installation Manual Download Page 2

Page: 2 / 3

AP-MNT-W4 Mount Kit | Installation Guide

4. Pushing towards the solid surface, rotate the AP clockwise until it clicks into place (see

Figure 2

Attach the AP to the Adapter

AP-to-Adapter Option

1. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to the

tab (see

2. Twist the adapter clockwise until it snaps into place in the tabs (see

Figure 3

Adapter Installation

3. Install two screws (and wall anchors if necessary), one above the other. Do not fully insert the screws into the

wall. Leave enough space between the screw head and the wall for the adapter.

4. Align the keyhole slots on the back of the adapter with the screws installed in

5. Place the larger opening on the keyhole slot over the screw and pull the AP down until it is securely attached

to the screws (see

Figure 4

AP-Adapter Wall Installation

This mounting option works only with a wall.

Summary of Contents for Aruba AP-MNT-W4

Page 1: ...to Solid Surface Option 1 Attach the plastic mount adapter to any solid surface such as a wall or ceiling as shown in Figure 1 a Install any necessary wall anchors Wall anchors are not included in th...

Page 2: ...naps into place in the tabs see Figure 3 Figure 3 Adapter Installation 3 Install two screws and wall anchors if necessary one above the other Do not fully insert the screws into the wall Leave enough...

Page 3: ...or adapter cable and coupler Use the following step to insert the RJ45 cable into the RJ45 coupler 1 Insert one end of the cable into the coupler until the cable snaps into place See Figure 5 Figure...