30
Appendix A
BIOS Error Codes
and System Specifications
A-1 BIOS Error Beep (POST) Codes
During the POST (Power-On Self-Test) routines, which are performed each time the system
is powered on, errors may occur.
Non-fatal errors
are those which, in most cases, allow the system to continue the boot-up
process. The error messages normally appear on the screen.
Fatal errors
are those which will not allow the system to continue the boot-up procedure. If
a fatal error occurs, you should consult with your system manufacturer for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The numbers
on the fatal error list (on the following page) correspond to the number of beeps for the
corresponding error. All errors listed, with the exception of Beep Code 8, are fatal errors.
BIOS Error Beep (POST) Codes
Beep Code
Error Message
Description
1 short
Refresh
Circuits have been reset (Ready to power up)
5 short, 1 long
Memory error
No memory detected in system
5 long, 2 short
Display memory read/write error
Video adapter missing or with faulty memory
1 long continuous
System OH
System overheat condition
A-2 Additional BIOS POST Codes
When BIOS performs the Power On Self Test, it writes checkpoint codes to I/O port 0080h.
If the computer cannot complete the boot process, a diagnostic card can be attached to the
computer to read I/O port 0080h.
System Specifications
System specifications for your HPE Apollo pc40 server can be found in the
QuickSpecs document. Refer to
www.hpe.com/servers/apollo-pc40
