HPC Tiger SHARK, Manual, Page: 58 / 65

BRUSH RETAINING SCREW
CUTTER SHAFT
WRENCH SLOT
BEFORE PERFORMING ANY
MECHANICAL MAINTENANCE ON
THE TIGER SHARK
™
, UNPLUG
POWER SUPPLY!
6.3
Replacement of Drive Belt
PREPARATION: To replace the Drive Belt
in the Tiger SHARK
™
you must remove
both the Deburring Brush, the Lower
Chassis Cover and the Back Cover.
Unplug the Tiger SHARK
™
from
electrical source and disconnect all
computer cables!
1. REMOVE DEBURRING BRUSH:
Using Adjustment Wrench provided,
locate the wrench slot on back of
machine (Fig. 1). Insert Adjustment
Wrench into slot, and align onto flat
section of cutter shaft. (You may have to
turn shaft manually to align flat area to
wrench). Hold wrench to secure shaft from
turning,while unscrewing Brush Retaining
Screw with Allen Wrench provided.
Remove Allen Screw and Washer.
Remove Deburring Brush by pulling brush
toward you and then down and out of
brush recess (Fig. 2).
2. LOOSEN LOWER CHASSIS COVER:
Using Allen Wrench provided,remove
Allen Screws from side panels of machine.
There are nine (9) Allen Screws on each side
of the chassis. Next, remove four (4) Allen
Screws from top of front platform.
Do not attempt to remove Lower Chassis
Cover until after the next step.
3. DETACH POWER SWITCH WIRES:
Pulling right side panel slightly outward,
you will see the power switch connectors
on rear of power switch. (CAUTION!
Please be sure you have unplugged
the machine from any power source)
Disconnect the two (2) wire tabs from
the power switch as shown (Fig. 3).
2 CONNECTORS
SIDE PANEL
BACK PANEL
TOP PLATFORM
Fig.3
NOTE: Connectors
are interchangeable.