HPC Tiger SHARK, Manual, Page: 43 / 65

2. The Machine Adjustments Screen will allow you to adjust Depth and Space by using the right and left arrows
indicated, in increments of .001" or .01mm. These adjustments can be saved by choosing SAVE, cancelled by
selecting CANCEL, or returned to the machine’s standard settings by choosing DEFAULT.
1. Select the TOOLS button from the Main Menu, then MACHINE ADJUSTMENTS.
Revert to the factory preset calibration
Moves cuts closer to (minus) or away
from (plus) the tip of the key for tip
gauged DSDs
Moves cuts closer to (minus) or away from
(plus) the shoulder of the key for shoulder
gauged DSDs
Causes the cutter to cut deeper (minus) or
shallower (plus) at the tip of the key
Causes the cutter to cut deeper (minus) or
shallower (plus)
Go back to the TOOLS Menu
Cancel any changes made (prior to saving)
Save the adjustments made
Select units of measure in thousandths of an INCH or
hundredths of a MILLIMETER
DEFAULT:
TIP SPACE:
SHOULDER SPACE:
TIP TO BOW:
DEPTH:
BACK:
CANCEL:
SAVE:
DATA TYPE:
MINUS (-) ARROW
.001" / .01mm.
PLUS (+) ARROW
.001" / .01mm.
If you find the keys are consistently cut outside of the specified dimensions, use the following directions to make
adjustments to the machine:
12. If the cuts are not within the .002-inch tolerance, then run the Auto Calibration again, cut 5-depths on a new
key blank, and measure them. If, after the 2nd calibration, the machine is still off by more than .002-inch (or you
need even tighter tolerances), then use the Machine Adjustments function to make small adjustments in the
depths (Fig. 7). Click on “TOOLS” , then “Machine Adjustments”.
13. Once the machine is in calibration, the operating program needs to be
reloaded. Remove the Auto-Calibrate Card, and install the Update Card.
Re-install the plate over the card. Note, the small hook in the center of the plate
faces IN, and ensures the card stays in place. Click “TOOLS” , then “SPECIAL
FUNCTION”
, then
”UPDATE FROM MMC CARD”
. When prompted, click
“CONFIRM” to begin the update process.The screen will go white for
approximately 7 minutes, then turn black for a shorter period. When the
operating program has been restored, the machine will beep and the screen
will show the standard main menu
(Fig. 8)
to let you know the machine is ready
for use.
Note: Any Machine Adjustments
that have been made will be
cleared by the Auto Calibration.
Prior to running subsequent Auto
Calibrations, make note of any
machine adjustments you have
made, as these may be needed
again.
Fig. 7
MINUS (-) ARROW
.001" / .01mm.
PLUS (+) ARROW
.001" / .01mm.
Fig. 8