8 Changing the control mode
The standard setting of the control mode depends on the machine type.
As an example, the change from DUAL to QUADRO control mode is described below.
Precondition Access level 2 is activated.
The display shows the operating mode.
1. Press «Enter».
The main menu is displayed.
2. Select the
< Configuration ➙ Control mode > menu.
Local mode is displayed as active line.
6 . 1 b a r 0 8 : 1 5 8 0 . 0 ° C
5.3 Control mode
Current menu
Local mode: DUAL
Active line with control mode to be adjusted
------------------------------
▶1 Venting period
·········
▶3 DUAL
▶4 QUADRO
3. Press «Enter» to switch into setting mode.
The display for
DUAL control mode flashes.
6 . 1 b a r 0 8 : 1 5 8 0 . 0 ° C
5.3 Control mode
Current menu
Local mode: QUADRO
Active line with changed control mode
------------------------------
▶1 Venting period
·········
▶3 DUAL
▶4 QUADRO
4. Use «UP» to select QUADRO.
5. Press «Enter» to accept the setting.
6. Press «Escape» repeatedly to return to the main menu.
Result The regulating mode DUAL has been switched to QUADRO.
Further information See chapter 4.7 for the functions of the control modes.
See chapter 7.6 for the parameters of the control modes.
8
Changing the control mode
9_9450 03 HCE
Quick User Guide Controller
SIGMA CONTROL 2 SCREW FLUID ≥1.1.3
13
