
6/21/2010
940
5
5)
TK Operation
WARNING:
Before use test all gas connections for leaks. Do not use TK if there is any evidence of leaking
gas. If leaking gas is suspected turn off the main gas supply and repair.
WARNING:
When TK is not in operation power must be turned off via wall switch or breaker.
WARNING:
Leaves, sticks, wood, paper, clothing, food material, should always be kept away from the TK.
Make sure that there is no vegetation or other objects over the top or sides of the TK that could ignite or
interfere with safe and proper operation.
IMPORTANT: As a safety feature if power to TK is turned “OFF” then immediately turned back “ON”, the
system will go into lockout mode. To reset, turn “OFF” power then back “ON” again.
Initial Start-up:
Several “on/off” cycles may be necessary to purge air in gas lines after system
installation. TK will lockout after 15 attempts to light pilot: Please power OFF then ON to restart.
TK START UP
1.
STOP! Read the safety information on “What to Do If Smell Gas” (Pg. 1).
2. Confirm there is no debris in TK (as mentioned in warnings).
3. Turn “ON” electrical power and gas to fire pit.
4. Using wall switch or remote, turn “ON” TK- this may take several cycles to
purge any air.
5. To reset after lockout, power unit down then restart.
6. Once TK has ignited,
DO NOT
leave unattended.
Sequence of Operation:
1. The hot wire igniter will be powered (glow red) for 5 seconds before valve opens.
2. The hot wire igniter will only be powered the initial 15 seconds of the 60 second pilot cycle. This
sequence will repeat up to 15 times (~15 minutes) before going into lockout. To reset, turn “OFF” power
then back “ON” again.
3. Flame will ignite and warm thermocouple- it may take 30 seconds at times for thermocouple to get hot.
If thermocouple is not hot in 60 seconds, system will shutdown then go back to Step 1.
4. Once thermocouple is hot, main valve will open allowing main burner to ignite.
5. If flame is blown out at anytime, system will shutdown, then automatically restart (Step 1).
TK SHUTDOWN
1. Turn “OFF” TK using remote control or wall switch.
IMPORTANT:
REMOTE CONTROL USE: YOU MUST ALSO TURN OFF POWER TO
REMOTE CONTROL SYSTEM TO PREVENT ACCIDENTAL START.