HP Z220 CMT Series, Maintenance And Service Manual, Page: 65 / 198

Table 2-2 Computer Setup (F10) Utility menu descriptions for the HP Z420, Z620, and the Z820
Workstations (continued)
Heading Option Description
Save Changes
and Exit
Saves changes to system configuration and exits the workstation setup.
Storage Device
Configuration Lists installed non-SCSI storage devices (except SATA devices) and provides options for
obtaining specific information about each device:
●
CD-ROM SATA0—Shows the ODD default settings.
●
Default Values (SATA defaults)—
◦
Translation Mode—Enables the BIOS to determine the translation mode used to
configure a formatted SATA or USB mass storage device. This prevents you from
needing to know how the mass storage device was formatted. Options are
Automatic, Bit Shift, LBA Assisted, User (Cylinders, Heads, Sectors), and Off.
Automatic is the default.
Ordinarily, you should not change the translation mode selected by the BIOS. If
the selected translation mode is not compatible with the translation mode that
was active when the drive was partitioned and formatted, the data on the disk is
inaccessible.
Storage Options Provides these options:
●
Removable Media Boot—Enables and disables the ability to start the workstation from
removable media.
●
SATA Mode—Sets the SATA emulation mode with the following options:
◦
RAID + AHCI—Both the RAID and AHCI OPROMs execute. This emulation mode
is the default and offers the best performance and most functionality.
◦
IDE —Offers standard SATA supports (four ports only).
●
Serial-ATA Controller—Enhanced, Compatable, or Disabled. The default is Enhanced.
This option is only available when in IDE-mode.
Boot Order Enables you to configure the boot, diskette drive, and hard disk drive orders by physically
reordering the menu entries. The following is the default boot order presented in the menu:
●
EFI Boot Sources
◦
USB Floppy/CD
◦
USB Hard Drive
◦
ATAPI CD/DVD Drive
●
Legacy Boot Service
◦
ATAPI CD/DVD Drive
◦
USB Floppy/CD
The Computer Setup (F10) Utility 53