Accessing the internal components of the computer
1.
If you need help preparing the computer for this installation, consult the removal and replacement
procedures in the HP Customer Self Repair Services Media Library at
service guide for your computer at
http://www.hp.com/support/manuals
2.
Power down the workstation, and then disconnect the power cord.
3.
Power down all external devices, and then disconnect them from the workstation.
4.
Remove the access panel by lifting up on the release latch and raising the panel from the chassis.
Installing the drive in an HP Z440 Workstation
If more than one of any of the following drives are to be installed in a system, a unique address for each drive
must be configured before installation:
●
HP Z Turbo Drive
●
HP Z Turbo Drive G2
●
HP Z Turbo Quad Pro
For configuration instructions, see
Installing multiple HP Z Turbo Drives or HP Z Turbo Quad Pro Drives
1.
Press down on the two green PCI retention clips (1) located inside the workstation until they release,
and then rotate them down to raise the retention clamp (2).
8
HP Z Turbo Drive Quad Pro installation
