7.
Replace the locking screws in the sides of the carrier.
Figure 28
Replacing the locking screws
Step 4—Completing the computer assembly
CAUTION:
Insert or remove the carrier (with a disk drive) only when the workstation is shut down.
Other procedures may result in system hangs, data loss, or even drive damage. The component
supplier’s user guide describes a procedure for inserting or removing the carrier (with drive) while the
workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft
Windows XP and Windows Vista do not support this action.
1.
After the drive case is installed in the computer, insert the drive carrier into the case.
a.
Press on the left side of the handle (1) to open the door.
b.
Insert the drive carrier.
c.
If shipping or moving the computer, lock the carrier by inserting the key (2) and turning it
counterclockwise (3).
CAUTION:
Always lock the drive before shipping or moving the computer. Failure to do so
might result in damage to your removable hard drive system.
Figure 29
Locking the carrier
ENWW
Step 4—Completing the computer assembly
17
