Virtual TapeServer Quick Setup Guide | 17
and install a certificate that is signed by a Certificate Authority, as described in the
Virtual
TapeServer Installation Guide
.)
1. From the console window, launch a browser and enter the following URL to access the
web interface:
http://localhost/
The VTS web interface is displayed:
Note
When accessing the web interface from a browser on a remote system, the VTS
web server will redirect the browser to use a secure connection to the fully
qualified domain name of the VTS server. However, the browser is not redirected
if you are accessing the web interface from the local console.
2. Click
Log In
and log in as a user with Administrative privileges.
3. Click
Supervisor Functions
on the navigation pane.
4. Click
Generate Web Server Certificate
.
5. When prompted, click
OK
to replace the existing web server certificate and restart the
web server.
7 Configure and label ports
After cabling the host server and external devices to the VTS server, you must configure the
ports using the VTS web interface. This will enable VTS to communicate properly with each type
of device (target or initiator).
A. Launch a web browser and enter the IP address or hostname of the VTS server in the
address field. The VTS web interface is displayed.
B. Click
Factory Setup
on the navigation pane.
C. When prompted to log in, enter
factory
as the username and
zfactoryz
as the password.
D. Click
Factory Options
on the Factory Setup page.
E. Again, enter the login credentials.