10
TippingPoint Hardware Safety and Compliance
WARNING!
The ports on the front of the product are Safety Extra-Low Voltage (SELV) circuits. SELV circuits
should only be connected to other SELV circuits.
WARNING!
This product might have more than one power supply source. All power sources must be
removed to de-energize the unit.
WARNING!
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
WARNING!
All optical interfaces and sources connected to this product and its modules must only use
Class 1 lasers. Using any other Laser Class source can create hazardous conditions to the user.
WARNING!
This product can contain Class 1 lasers. Do not stare into the laser beam or view it directly
with optical instruments. Install covers for the laser connectors when they are not in use.
WARNING!
The cards and modules can get hot during operation. When removing a card or module,
hold it by the faceplate and bottom edge. Allow the card or module to cool before touching any other part
of it or before placing it in an antistatic bag.
WARNING!
The product uses double pole/neutral fusing. Use caution when servicing this product.
Rack and Clearance Requirements
Tipping Point recommends that you mount the product in a standard 19-or 23-inch rack. The vertical hole
spacing on the rack rails must meet standard EIA-310-C requirements, which call for a 1.75 inch (44.45
mm) spacing. Ensure that you have a minimum of three inches clearance at the side of the ventilation slots.
Ventilation and Location
Ventilation and proper location are essential to the proper operation of the product. Follow these
guidelines to ensure that the product receives adequate ventilation.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
•
Ensure that the unit is positioned properly on the rack
•
There should be three inches clearance at the ventilation openings.
•
When mounting this unit in an enclosed or multi-rack assembly, the operating ambient temperature of
the rack may be greater than the room ambient temperature. Ensure that the maximum ambient
temperature of 104° F (40 ° C) is not exceeded.
