HP Tc2110 - Server - 128 MB RAM, Maintenance Manual

Page: 85 / 118

Chapter 7 Replacing Parts
Figure 7-5. Removing Hard Disk Drive (HDD) and Tray
Replacing a Hard Disk Drive (Tray Mounted)
Follow these steps to replace the third hard disk drive (HDD) mounted in the fourth shelf. The second and
third drive trays are identical, but the forth drive tray is reserved for a hard drive (IDE or SCSI). The fourth
drive tray provides four raised mounting posts to mount hard drives without the use of any mounting
brackets.
1. Remove the hard disk drive from the shipping container.
2. Set the jumper on the back of the drive to “CS” (Cable Select). Refer to the hard disk drive
documentation for detailed instructions.
3. Attach the third HDD to mounting tray using the four screws at the bottom of the tray.
CAUTION
All mounting screws used with the hard disk drive must be #6-32 and not exceed ¼-inch
in length. Longer screws may cause internal damage to the mass storage device. Damage
caused by incorrect mounting screws is not covered by the HP warranty.
4. Guide the HDD tray into the chassis opening, with the cable connectors toward the rear of the chassis.
5. At the rear of the HDD, carefully connect the power and data cables.
For IDE models, the third HDD is connected to the cable for IDE-2.
For SCSI models, the SCSI cable has five connectors and one termination. There should be a connector
available for the third HDD.
6. Replace the upper bezel.
NOTE If this is the initial installation of a hard disk drive in this location, it is necessary to
remove the bezel drive cover from the upper front bezel.
7. Replace the left side cover.
79