Preparing for Installation
Internal Drives
1-4
Installation Overview
Installing the HP SureStore T20 tape drive is a simple procedure requiring
no special skills, providing that your system meets the prerequisites and
you have the right tools. The hardware installation process should take less
than an hour.
See “Checking System Prerequisites” on page 1-7.
•
Properly installed and configured SCSI controller
•
CD-ROM drive to load software
•
Empty 5¼-in bay
•
Mounting hardware, if required for your computer
•
SCSI cable with available 50-pin connector
See “Preparing the Computer” on page 2-3.
•
Run TapeAssure (optional)
•
Perform a normal system shutdown
•
Remove power cables
•
Remove cover
•
Remove cover plate and any mounting hardware from bay
See “Preparing the Tape Drive” on page 2-6.
•
Check SCSI ID and reset if necessary
•
Check termination and change if necessary
•
Attach rails or other mounting hardware if required for your computer
See “Installing the Tape Drive in the Bay” on page 2-9.
•
Slide drive into bay
•
Attach SCSI cable
•
Attach power cable
•
Secure drive in place with screws
•
Replace computer’s cover
•
Reconnect power cables
See “Verifying the Installation” on page 2-13.
•
Switch on computer and boot up
•
Install TapeAssure from CD-ROM
•
Run TapeAssure and perform a test backup and restore
See “Installing Backup Software” on page 2-14.
•
Install backup software from CD-ROM
See “Installing Driver Software” on page 2-14.
•
Install driver software from CD-ROM
Check System
Prerequisites
Prepare
Computer
Prepare
Tape Drive
Install
Tape Drive
Verify the
Installation
Install Backup
Software
Install Driver
Software
