Table 5-2
Computer Setup—Security (continued)
Option
Description
NOTE:
This selection will only appear when at least one drive that supports the DriveLock feature
is attached to the system.
CAUTION:
Be aware that these settings take place immediately. A save is not necessary.
CAUTION:
Be sure to document the DriveLock password. Losing a DriveLock password will render a
drive permanently locked.
After you select a drive, the following options are available:
Set DriveLock Master Password. Sets the drive’s master password but does not enable DriveLock.
Enable DriveLock. Sets the drive’s user password and enables DriveLock.
●
Secure Erase
Lets you select a hard drive to completely erase.
Once a hard drive has been erased with a program that utilizes Secure Erase firmware commands, no
file recovery program, partition recovery program, or other data recovery method will be able to
extract data from the drive.
●
Allow OPAL Hard Drive SID Authentication
System Management
Command
Allows authorized personnel to reset security settings during a service event. Default is enabled.
Restore Security
Settings to Default
This action resets security devices, clears BIOS passwords (not including DriveLock), and restores settings
in the Security menu to factory defaults.
Computer Setup—Advanced
NOTE:
Support for specific Computer Setup options may vary depending on the hardware configuration.
Table 5-3
Computer Setup—Advanced (for advanced users)
Option
Heading
Display Language
Lets you select the language of the menus in F10 Setup and the keyboard layout.
Scheduled Power-On
This feature wakes the system up from a powered off state at a specified date and time.
Boot Options
Select the devices that the computer can boot from, as well as other options, including:
●
Startup Delay(sec). Enabling this feature will add a user-specified delay to the POST process. One
purpose for the delay is to provide additional time to activate hotkeys such as
Esc
for the Startup
Menu or
F10
for Computer Setup.
●
Fast Boot. Default is enabled for Windows 8.1 or later, and disabled for Windows 7 systems.
●
CD-ROM Boot. Default is enabled.
●
USB Storage Boot. Default is enabled.
●
Network (PXE) Boot. Default is enabled.
●
Prompt on Memory Size Change. Default is enabled.
●
Prompt on Fixed Storage Change. Default is disabled.
●
After Power Loss. Default is Power Off.
■
Power off—causes the computer to remain powered off when power is restored.
■
Power on—causes the computer to power on automatically as soon as power is restored.
Computer Setup (F10) Utilities
65
