Removal and replacement procedures 25
5.
Remove the mezzanine card.
CAUTION:
To prevent damage to the workstation blade, apply pressure over the mezzanine
connector when installing the mezzanine card. Do not apply pressure to the edges of the card.
To replace the component, reverse the removal procedure.
Workstation A system board
To remove the component:
1.
Power down the workstation blade (on page
11
).
2.
Remove the workstation blade (on page
11
).
3.
Access the internal workstation components (on page
12
).
4.
Remove the workstation A USB key, if installed.
5.
If installed, remove one of the following:
o
Hard drive (on page
13
)
o
Cache module battery (on page
22
)
6.
Remove all DIMMs ("
DIMMs
" on page
15
).
7.
Remove any mezzanine cards ("
Mezzanine card
" on page
24
).
8.
Remove the heatsink ("
Heatsink
" on page
15
).
9.
Remove the cache module battery cable, if installed.
