HP ProLiant DL385p, Maintenance And Service Manual

Page: 53 / 102

Removal and replacement procedures 53
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
To remove the component:
1.
Power down the server (on page 25 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Extend (" Extend the server from the rack " on page 26 ) or remove (" Remove the server from the rack "
on page 27 ) the server from the rack.
4.
Remove the access panel (" Access panel " on page 30 ).
5.
Disconnect any external cables that are connected to the expansion board.
6.
Disconnect any internal cables that are connected to the expansion board.
7.
Remove the PCIe riser cage (" Remove the primary PCIe riser cage " on page 33 , " PCIe riser cage
LED " on page 87 ).
8.
Remove the expansion board.
To replace the component, reverse the removal procedure.
Full length expansion board
CAUTION: To prevent damage to the server or expansion boards, power down the server
and remove all AC power cords before removing or installing the PCIe riser cage.
To remove the component:
1.
Power down the server (on page 25 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.