HP ProLiant DL380 Gen9, User Manual

Page: 78 / 215

Hardware options installation 78
13.
Install the access panel (on page 28 ).
14.
Slide the server into the rack.
15.
Connect each power cord to the server.
16.
Connect each power cord to the power source.
17.
Power up the server (" Powering up the server " on page 26 ).
2-slot PCI riser cage option
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. Pressing the Power On/Standby
button does not shut off system power completely. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server
unless all PCI slots have either an expansion slot cover or an expansion board installed.
To install the component:
1.
Power down the server (on page 26 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 26 ).
o
Remove the server from the rack (on page 27 ).
4.
Remove the access panel (on page 27 ).
5.
Remove the standard PCI riser from the primary slot.