Removal and replacement procedures 39
DIMMs
To remove the component:
1.
Power down the server (on page
26
).
2.
Extend the server from the rack (on page
26
).
3.
Remove the access panel.
4.
Open the DIMM slot latches.
5.
Remove the DIMM.
To replace the component, reverse the removal procedure.
Memory options
You can expand server memory by installing PC4200 DDR2 unbuffered SDRAM DIMMs. The system
supports up to four ECC DDR2 SDRAM DIMMs.
NOTE:
By default, the server is set to
Advanced ECC Support
. Refer to "HP ROM-Based Setup Utility (on
page
49
)" for more information.
The server supports standard memory configuration for maximum performance with up to 8 GB of active
memory (four 2-GB memory modules).
DIMM installation guidelines
Observe the following guidelines when installing additional memory:
•
DIMMs installed in the server must be unbuffered DDR2 SDRAM, 2.5 V, 64 bits wide, and ECC.
•
All DIMMs installed must be the same speed (DDR2 PC4200). Do not install DIMMs supporting
different speeds.
•
If only a single DIMM is installed, HP recommends installing it in slot 1A.
BIOS detects the DIMM population and sets the system as follows:
•
Single-bank mode: DIMMs installed in one bank only.
•
Dual-bank interleaved mode: DIMMs installed in both banks with equal bank capacities.
Summary of Contents for ProLiant DL320 Generation 4
