Removing and replacing a
Removing and replacing a boot device
boot device drive
drive
The boot device supports two physical drive sizes:
22110 (110 mm)
2280 (80 mm)
Two drives of the same physical size, or one of each size, can be installed at the same time. Depending on the replacement drive size, you
might need to relocate the M.2 drive retaining latches on the boot device.
CAUTION:
CAUTION:
The boot device and the drives installed on the boot device are not hot-pluggable. To remove the boot device, or a drive
from the boot device, you must first power down the server.
CAUTION:
CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:
CAUTION:
Before replacing a DIMM, expansion card, or other similar PCA components due to a perceived hardware error, make
sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.
Prerequisites
Prerequisites
Review the boot device drive bay LEDs to identify the failed drive.
Procedure
Procedure
1. Back up all server data.
2. If physically powering down a server with the front bezel installed, remove the front bezel .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
10. Remove all drives from the boot device.
To replace the component, reverse the removal procedure.
Removing and replacing a boot device drive
121
Summary of Contents for ProLiant DL20 Gen10 Plus
