HP ProLiant DL160 G5P, Service Manual

Page: 51 / 95

Removal and replacement procedures 51
Figure 24 Installing the non-hot-plug hard drive disk into the carrier
Figure 25 Fastening the non-hot-plug hard drive disk to the carrier
To install a non-hot-plug hard drive in the server:
1.
Remove the hard drive blank from front of system if installed.
2.
Push the hard drive assembly into the drive bay until it stops.
3.
Fasten the screw with the T-15 wrench provided to secure the hard drive to the chassis.
4.
Connect the cabling from the HDD backplane to the drive using the cables provided.