Removal and Replacement Procedures
NIC Modules
To remove the standard NIC module:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blad e Preparation” section in this chapter.
2. Remove the access panel. Refer to the “ Access Panel” section in this chapter.
3. Remove the standard NIC module:
a. Turn the quarter-turn standoff latches on the Smart Array 5i Plus Controller module
counter clockwise (1).
b. Lift the Smart Array 5i Plus Controller module from the system board (2).
c. Turn the quarter-turn standoff latches on the FC mezzanine card counter-clockwise
(3).
d. Lift the FC mezzanine card away from the system board (4).
CAUTION: Lifting one edge of the module at a time may damage the connectors. Be sure to
lift the module straight up.
Figure 2-19: Removing the NIC module
Reverse steps 1 through 3d to replace a NIC module.
2-20
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
