HP ProCurve 2510-24, Manual

Page: 22 / 318

1-6
Getting Started
Conventions
Command Prompts
In the default configuration, your switch displays a CLI prompt similar to:
ProCurve Switch 2510-24#
To simplify recognition, this guide uses
ProCurve
to represent command
prompts for all models. For example:
ProCurve#
(You can use the hostname command to change the text in the CLI prompt.)
Screen Simulations
Figures containing simulated screen text and command output look similar
to this:
Figure 1-1. Example of a Figure Showing a Simulated Screen
In some cases, brief command-output sequences appear outside of a
numbered figure. For example:
ProCurve(config)# ip default-gateway 18.28.152.1/24
ProCurve(config)# vlan 1 ip address 18.28.36.152/24
ProCurve(config)# vlan 1 ip igmp
Port Identity Examples
This guide describes software applicable to both chassis-based and stackable
ProCurve switches. Where port identities are needed in an example, this guide
uses the chassis-based port identity system, such as “A1”, “B3 - B5”, “C7”, etc.
However, unless otherwise noted, such examples apply equally to the
stackable switches, which for port identities typically use only numbers, such
as “1”, “3-5”, “15”, etc.
ProCurve(config)# show version
Image stamp: /sw/code/build/dosx(ndx)
Dec 11 2007 11:44:02
U.11.03
1340
Boot Image: Primary