3.
Lay the computer on its side with the rear facing toward you.
4.
Disconnect the heatsink control cable from the system board and remove the heatsink
Heat sink
assembly on page 67
).
5.
Rotate the locking lever to its full open position
(1)
.
6.
Carefully lift the processor from the socket
(2)
.
CAUTION:
Do NOT handle the pins in the processor socket. These pins are very fragile and
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
CAUTION:
The heatsink must be installed within 24 hours of installing the processor to prevent
damage to the processor’s solder connections.
To install a new processor:
1.
Place the processor in its socket and close the retainer.
2.
Secure the locking lever.
If reusing the existing heat sink, go to step 3.
If using a new heat sink, go to step 6.
3.
If reusing the existing heat sink, clean the bottom of the heat sink with the alcohol pad provided
in the spares kit.
4.
Apply the thermal grease provided in the spares kit to the top of the processor and install the
heat sink atop the processor.
5.
Go to step 7.
6.
If using a new heat sink, remove the protective covering from the bottom of the heat sink and
place it in position atop the processor.
7.
Secure the heat sink to the system board and system board tray with the 4 captive screws and
attach the heat sink control cable to the system board.
Processor
69
Summary of Contents for Pro 3005 - Microtower PC
Page 4: ...iv About This Book ...
