HP Omnibook XE3 (Technology Code GF)
Removal and Replacement
2-5
Removing an SDRAM Module
(User-Replaceable)
The notebook has no SDRAM on its motherboard, but has two slots for SDRAM modules.
Table 2-4. SDRAM Module Replacement Part Numbers
Description
Part Number
Exchange Part Number
Module, SDRAM, 128 MB, PC133 SODIMM
1818-8504
Module, SDRAM, 256 MB, PC133 SODIMM
1818-8635
Caution
Provide proper grounding and handle the SDRAM module only by its edges, or you could damage
the module through electrostatic discharge.
Required Equipment
•
#0 Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. On the bottom of the notebook, loosen the screws holding the appropriate SDRAM cover (the
cover retains the screws), and remove the cover.
Figure 2-3. Removing the SDRAM Covers
3. Press outward to release the latches at the sides of the SDRAM module, so the free edge of the
module pops up.
4. Pull the module out of the connector.
Reassembly Notes
•
Gently press the SDRAM module into the connector at an angle of about 30°, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.
Summary of Contents for Omnibook XE3
