To install a DSIC interface module:
1.
Remove the screws on the two horizontal neighboring SIC filler panels and the slot divider by using
a Phillips screwdriver.
2.
Draw out the slot divider.
3.
Push the DSIC interface module into the DSIC slot along the guide rails until it closely mates with the
rear panel of the router.
4.
Use a flat-blade screwdriver to fasten the captive screws to fix the DSIC interface module to the
router.
Figure 31
Install a DSIC interface module
1
2
3
4
5
Connecting interface cables
Before powering on the router, connect the interface cables of the router.
Connecting an Ethernet cable
To connect a copper Ethernet port, connect one end of the Ethernet cable to an Ethernet port on the router
and the other end to the peer device. For a 10/100 Mbps copper Ethernet port that supports MDI/MDIX
autosensing, use a straight-through cable or crossover cable to connect the port to a hub or LAN switch.
Figure 32
Connect an Ethernet cable to a WAN port
22
