HP MFP Analog Fax Accessory 300, Fax Manual

Page: 18 / 316

10 Chapter 1 Setting up
ENWW
8 Insert the fax card connector (1) into the formatter fax connector
(2), see Figure 1-9. The connector (2) on the formatter board is
labeled “FAX ACCESSORY.” The ends of the card should slide
into the two guides (3) and the card should “snap” into place
when it is fully seated.
Verify that the accessory is securely seated. The phone
connector (4) on the fax card should be aligned with the opening
(5) in the back of the formatter cage, see Figure 1-9.
Figure 1-9
Installing the fax card on the formatter - HP LaserJet 4345mfp
9 Close the formatter cage door and replace the MFP formatter
cover.
Note
When connecting the fax accessory to a phone line, ensure that the
phone line being used for the fax accessory is a dedicated line that is
not used by any other devices. This line should be an analog line,
because the fax will not function correctly if connected to some digital
PBX systems. If you are unsure of what type of line you have, contact
your telecom provider. Also, HP recommends using the phone cord that
comes with the fax accessory to ensure that the accessory functions
correctly.
WARNING!
The phone wall jack is electrified and you might receive an electric
shock if you touch the connector wires. When installing the phone
cable, do not touch the wall phone jack or, if you connect the phone
cable into the wall phone jack first, do not touch the wires on the
phone cable connector at other end.