2-6
Installing the RSVLC-0501
Installation Procedures
Insta
lling
the
RSV
LC-0501
2.
Check the LEDs on the access point as described below.
When the access point is powered on, it performs its diagnostic self test.
The self test takes approximately 50 seconds to complete.
LED Behavior:
During the self test:
•
The Power, LAN, Radio 1, and Radio 2 LEDs turn on and off several
times during phases of the self test.
When the self test completes successfully:
•
The
Power
LED remains on green.
•
The
LAN
and
Radio
LEDs on the top of the access point go into their
normal operational mode:
–
If the ports are connected to active network devices, the LEDs
should be blinking.
–
If the ports are not connected to active network devices, the LEDs
stay off.
If the LED display is different than what is described above, especially if
the
Power
LED does not stop blinking or turns on amber, the self test has
not completed correctly. Refer to chapter 5, “Troubleshooting” for diag-
nostic help.
Power
Radio 1
11b/g
Link/Activity
Radio 2
11a/b/g
LAN
ProCurve
Access Point
530
NA
J8986A
Wireless LEDs
Ethernet LED
Power LED
