3
Installation Steps
To install the HP ProCurve High-Speed Transceivers, follow these steps:
1. Insert the transceiver into an HP networking device's transceiver slot
and secure the retaining screws.
2. If the transceiver slot is in a module, install the module into the switch.
3. As necessary for the type of networking device into which the trans-
ceivers are installed, reset or reboot device.
4. Connect the network cable to the transceiver and check the transceiver
and network device for correct operation.
Details on these steps are provided in the rest of this document.
Insert the Transceiver Into the Slot
The transceivers are installed into an HP networking device, as follows:
1. If you are installing the transceiver into the HP ProCurve 2424M Gigabit
Stacking Module, first remove the module from the switch. Then, for
that module and for all other networking devices, using a flat-bladed or
Torx T-10 screwdriver, unscrew the two retaining screws on the slot
cover plate or existing transceiver, and remove it from the module or
device.
2. Touch a grounded, metal object (such as a powered-on switch) to
discharge any static electricity on your body, then carefully remove the
transceiver from its protective anti-static packaging. Hold the trans-
ceiver by its bulkhead or edges, taking care not touch any of its board
components or metal connectors.
1
7
Transceiver Ports
25
26
10/100Base-T Ports (1-24)
(all ports are HP Auto-MDIX)
!
LED Mode Select
Mode
Link
Mode
Link
Reset
1
2 3
4
5
6 13 14 15 16 17 18
7
8 9
24
10 11 12 19 20 21 22 23
Act FDx Max
!
Fan
Status
25 26
Self
Test
Console
hp procurve
switch 2524
j4813a
Clear
Power
Fault
( See manual for supported transceivers)
loosen these screws and remove the cover plate
59692336.fm Page 3 Monday, October 9, 2000 4:08 PM
