24
Chapter 2
Installing the HP-HSC ATM/155 Adapter
Installation Steps
a. Position the ATM adapter in the right-hand or center slot, and line up
its connector over the connector on the 74x Single Board Computer.
b. Press the adapter firmly down to fully engage the connectors.
c. Secure the ATM adapter to the adapter fixture on the 74x by using
the two plastic screws and washers supplied with the adapter.
d. Secure the adapter to the 74x’s front panel expansion plate by using
the two screws that were used with the blank panel. Figure 2-3 below
shows the two locations where you need to secure the adapter.
Figure 2-3
Securing the ATM Adapter
e. If you are installing a second ATM adapter, repeat substeps a through
d to install the second adapter in the remaining open slot.
If you are not installing a second adapter, go to step 11.
Step 11. Install a blank cover on any open slots, by using a No. 1 Pozidriv
screwdriver to tighten the screws. Figure 2-4 below shows where the
screws are located.
Summary of Contents for J3420B HP-HSC ATM/155
Page 4: ...4 ...
Page 6: ...6 Contents ...
Page 10: ...10 ...
Page 18: ...18 Chapter1 Before Installing the HP HSC ATM 155 Adapter Cables ...
