8
Installing the 10Base-FL Module in an Unused Slot
4.
Make sure the module’s extractor handles are in the open position
(rotated away from the face plate), then push the module into the slot until
you feel the extractor handles contact the switch chassis. (The handles
will move slightly upwards when they contact the chassis.)
5.
Seat the module in the slot by simultaneously pushing in on both extractor
handles until they are firmly seated against the front panel of the module
(in the closed position).
Figure 4.
Extractor Handles in the Closed Position
If the switch has power during module installation, the LEDs will behave
as described in the “Slot and Port LED Behavior” table on the next page.
(If you have not already done so, install the LED label strip as described
in step 1 on page 6.)
Figure 5.
Self-Test and Fault LEDs
6.
Tighten the captured screw in each handle by using a flat-blade or Torx-
10 screwdriver.
Be careful not to overtighten the screws
.
%XTRACTOR (ANDLES IN THE ä#LOSEDå 0OSITION
Self-test LED
Slot Fault LED
blue_2b.fm5 Page 8 Monday, September 23, 1996 8:03 AM
