7
Installing the 10Base-FL Module in an Unused Slot
Figure 2.
Remove the Cover Plate from an Unused Switch Port
3.
Holding the module by its edges—taking care not to touch the metal
connectors—position the module in front of an open slot on the switch
by aligning the edges of the module with the small grooves near the bottom
of the module slot, as shown in the next illustration.
Figure 3.
Extractor Handles in the Lowered (Open) Position
Replace the Blank LED Label
Strip with the 10Base-FL Strip
LED Label Slot
Module Slot “A”
Module Slot “B”
Loosen These Two Screws
Extractor Handles in the
“Open” Position
Module
Groove
Module
Groove
blue_2b.fm5 Page 7 Monday, September 23, 1996 8:03 AM
