HP Integrity rx5670, Hardware Installation Manual

Page: 21 / 46

Chapter 2
Installing Additional Components
Installing Power Supplies and Internal Disk Drives
21
Figure 2-3 Power Cord Receptacles at Rear of Chassis
1. Grasp the handle in one hand and support the HotSwap Power Supply with the other.
2. Slide the HotSwap Power Supply into the server. If the server is powered on, the HotSwap Power Supply
LED should illuminate immediately.
3. Tighten the captive T-15 screw located to the right of the handle near the top of the HotSwap Power
Supply.
Installing HotPlug Disk Drives
HotPlug Disk Drive Load Order
The internal disks drives, known as HotPlug Disk Drives, must be installed in a specific order. The HotPlug
Disk Drives are located in the Disk Media Housing, found at the front of the chassis. Within the Disk Media
Housing are slots that accommodate up to four HotPlug Disk Drives. HotPlug Disk Drive installation order is
shown in Table 2-1.
Installing a HotPlug Disk Drive
To install a HotPlug Disk Drive, perform the following steps:
1. Ensure the HotPlug Disk Drive latch is in the open/unlocked position.
2. Gently slide the HotPlug Disk Drive into the chassis until it locks into place.
Table 2-1 HotPlug Disk Drive Load Order
Disk Slot
First Disk (A) Lower Left
Second Disk (B) Lower Right
Third Disk (C) Upper Left
Fourth Disk (D) Upper Right