HP Integrity rx5670, Hardware Installation Manual

Page: 29 / 46

Chapter 2
Installing Additional Components
Installing Processors and Memory
29
Installing Memory
To install memory, perform the following steps:
1. Loosen the captive T-15 screws that secure the Memory Extender Board DIMM Retainer.
2. Remove the DIMM Retainer from the Memory Extender Board.
3. Align the Memory DIMM with the socket located on the Memory Extender Board.
4. Push gently and evenly on each side of the Memory DIMM until it seats in the socket.
NOTE
Ensure that the extraction levers are in the closed position.
5. Repeat steps 3 and 4 until all Memory DIMMs are seated in their sockets.
6. Align the DIMM Retainer on the Memory Extender Board.
7. Tighten the captive T-15 screws to secure the DIMM Retainer to the Memory Extender Board
Figure 2-9 Memory DIMM Location
Installing a Memory Extender Board
CAUTION Ensure that a Memory Extender Board is installed in slot MX0 (right slot). If the system is
configured with only one Memory Extender Board a memory filler panel must be installed in
slot MX1 (left slot). Failure to observe this caution will result in system failure.
To install a Memory Extender Board, perform the following steps:
1. Remove the filler panel located in slot MX1 if you are installing a second Memory Extender Board.
2. Ensure the Memory Extender Board extraction levers are positioned in the outward, unlocked position.
3. Align the Memory Extender Board with the front and rear Card Guides.
4. Slide the Memory Extender Board down until it begins to seat in the socket located on the System
Baseboard.