Description
The H8/3003 emulator has several dedicated configuration items which
allow you to specify the emulator’s interaction with the target system
and the rest of the emulation system. These items are:
ba
Enable/disable bus arbitration with target system.
chip
Select processor to be emulated.
clk
Select internal/external clock source.
dbc
Enable/disable to drive background cycles to target
system.
drst
Enable/disable to drive reset to target system.
mode
Determine emulator processor operation mode.
nmi
Enable/disable NMI (non maskable interrupt) from
target system.
rrt
Restrict emulator to real time runs.
rsp
Specify system stack pointer value to load upon
each transition from emulation reset to the monitor.
tdma
Enable/disable tracing internal DMA cycles.
trfsh
Enable/disable tracing refresh cycles.
trst
Enable/disable target system reset.
Complete explanations of all configuration items are given in chapter 4
of this manual.
H8/3003 Emulator Specific Command Syntax A-3
Summary of Contents for H8/3003
