6.
To install an SSD, slide the connector end of the SSD into the system board connector (1), and then
secure the other end of the SSD to the system board with the screw (2).
7.
Replace the computer head unit’s display panel. See
Replacing the display panel on page 32
.
8.
Attach the computer head unit to the stand. See
Attaching the Engage One head unit to the stand
on page 25
9.
Reconnect the power cord and press the power button.
Inserting an internal SD card
1.
Turn off the computer properly through the operating system, and turn off any external devices.
2.
Disconnect the power cord from the computer.
IMPORTANT:
Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
3.
Remove the computer head unit from the stand. See
Removing the Engage One head unit from the stand
on page 24
.
4.
Remove the display panel from the computer head unit. See
Removing the display panel on page 31
.
Inserting an internal SD card
41
Summary of Contents for Engage One Retail System 143
Page 4: ...iv About This Guide ...
Page 8: ...viii ...
