HP E3472A, User Manual, Page: 39 / 153

-i <internet>
The IP address which you obtained from your network administrator.
-g <gateway>
The gateway address. Setting the gateway address allows access outside
your local network or subnet.
-p <port>
This changes the base TCP service port number.
The default numbers (6470, 6471) can be changed if they conflict with some
other products on your network. TCP service port numbers must be greater
than 1024. If you change the base port, the new value must also be entered in
the /etc/services file on the host computer. For example, you could modify
the line:
hp64700 6470/tcp
6
Disconnect the power cord from the HP E3472A/73A Emulator, and
connect the the HP E3472A/73A Emulator to your network.
This connection can be made by using either the 10BASE-T connector or the
10BASE2 (BNC) connector on the HP E3472A/73A Emulator. Do not use
both connectors at the same time.
7
Set the configuration switches to indicate the type of connection that
is to be made.
Switch S1 must be set to OPEN, indicating that a LAN connection is being
made.
Switch S5 should be 1 if you are connecting to the BNC connector:
Switch S5 should be 0 if you are connecting to the 10BASE-T connector:
Set all other switches to CLOSED.
8
Connect the power cord to the HP E3472A/73A Emulator.
9
Verify your HP E3472A/73A Emulator is now active and on the
network. See "To verify LAN communications" in this chapter.
Connecting to the Host Computer
To configure LAN parameters using the built-in terminal interface
24