5
Place the probe head onto the interposer using the three alignment
pins of the interposer and the three alignment holes of the probe
head as shown in the figure below.
Alignment Pins Placement
6
Move the top sliding clamp forward on the probe end until it holds
the clamp posts of the bottom clamp.
7
Tighten the screw on the underside of the bottom clamp.
If the screw is too loose, the probe head will not make good contact with the
microprocessor pins.
To connect to the slot 1 Deschutes target system
12
Summary of Contents for E2492A
Page 29: ...28 ...
Page 32: ......
Page 33: ... E2492 92000 E2492 92000 HP Part Number E2492 92000 Printed December 1997 ...
