Mounting the E-MSM466-R
Pole installation
1.
Locate the E-MSM466-R mount bracket. Note that the four screw holes (1) in Figure 4 are not
used for pole mounts, only wall mounts.
Figure 4 Mounting bracket
1 2
3
4
4. Bracket bolt hole (x2)
1. Screw holes (x4) (screws shown)
2. Pole clamp slot (x4
3. Pole cut out
2.
Refer to Figure 5. Locate the two bracket bolts (5), the two lock washers, and the four flat
washers. Onto each bracket bolt (5), thread a lock washer followed by a flat washer. Push
both washers against the bracket bolt (5) head.
3.
Place the E-MSM466-R bracket post up on a table.
4.
Position the bracket (4) over the bracket posts (6) so that the holes in the bracket (4) and the
bracket posts (6) align.
5.
On one side of the E-MSM466-R, slide in a second flat washer between the bracket (4) and
the bracket post (6), and while holding the edge of this flat washer, thread the bracket bolt
(5) (with the lock washer and flat washer already threaded) through the hole in the bracket
(4), through the second flat washer, and then screw the bracket bolt (5) sufficiently into the
bracket post (6) so that the threads fully grip.
Mounting the E-MSM466-R
11
