22.
If it is necessary to replace the display bezel or any of the display assembly internal components,
remove the following screw covers and screws:
(1)
Two rubber screw covers on the display bezel bottom edge. The display rubber screw covers
are included in the Display Rubber Kit, spare part number 480442-001.
(2)
Two Phillips PM2.5×7.0 screws.
23.
Flex the inside edges of the top edge
(1)
, the left and right sides
(2)
, and the bottom edge of the
display bezel
(3)
until the bezel disengages from the display enclosure.
24.
Remove the display bezel
(4)
. The display bezel is available using the spare part number
486532-001.
25.
If it is necessary to replace the display inverter, release the display inverter
(1)
as far from the
display enclosure as far as the display panel cable and backlight cable allow.
Component replacement procedures
81