HP Compaq Evo D310, Upgrade Manual

Page: 23 / 28

Upgrading and replacing hardware
Evo D310 Micro Desktop 23
Replacing the system board
1 Switch off the PC and remove the PC’s cover. Refer to page 10.
2 Remove the main memory (page 12) and processor (page 21) from the old system board.
3 Remove all data, power and other cables from the old system board.
4 Remove the 8 screws securing the system board.
5 Remove the old system board by carefully disengaging the rear connectors then carefully lifting it out
of the PC.
6 Insert the new system board, lining up the rear connectors carefully, and fasten the screws to secure
the board in place.
7
Replace the main memory (page 12) and processor, making sure you remember to use a new thermal
interface (page 21).
8 Reconnect all cables to the new system board (page 13).
9 Check the configuration switches are in the correct positions (as shown in the table on “Configuration
Switches” on page 24).
10
Replace the cover and front panel. Refer to page 10.
Screw positions