Upgrading and replacing hardware
Evo D310 Micro Desktop 17
Configuring an IDE device after installation
After installing any device, you can check via the Summary Screen that your PC has correctly identified
the new configuration. To view the Summary screen, press
F8
during startup, then select
Summary
from
the list of options.
If the configuration is not correct, run the
Setup
program to configure the device. To enter the
Setup
program, press
F8
during startup, then select
Setup
from the list of options.
IDE drives are automatically detected by the
Setup
program. However, a newly installed device may
required that you install an appropriate device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from the support web site.
The IDE cables in your PC are cable select. You must, therefore, set the jumpers on any IDE devices you
install to cable select. See the documentation for the device for more information.
Summary of Contents for Compaq Evo D310
Page 1: ...upgrade guide Compaq Evo D310 Micro Desktop www hp com go support ...
Page 8: ...8 ...
Page 27: ......
Page 28: ...Created in France June 2002 ...
