HP Apollo 2000 System, User Manual

Page: 98 / 203

b. Install the FlexibleLOM 2U node riser cage assembly and secure it with five T-10 screws .
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all PCI riser
cages or rear I/O blanks are installed, and do not operate the node unless all PCI slots have
either an expansion slot cover or an expansion board installed.
IMPORTANT:
If the PCIe riser cage assembly is not seated properly, then the server does not power up.
10. Install the node into the chassis .
11. Connect all peripheral cables to the node.
12. Power up the node .
FlexibleLOM 1U node riser cage assembly option
Procedure
1. Power down the node .
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis .
4. Place the node on a flat, level surface.
5. If installed, remove the single-slot left PCI riser cage assembly .
6. Remove the rear I/O blanks .
7. Remove the PCI blank.
98 FlexibleLOM 1U node riser cage assembly option