HP AlphaServer GS80, Upgrade Manual

Page: 86 / 88

B-14 AlphaServer GS80 Upgrade Manual
Door Removal
1. Open the front door and remove the screw at the cabinet end of the ground strap.
2. If the door has a service pouch on it, remove it and place it inside the cabinet.
3. Disconnect all cables to the OCP.
4. Remove the outer screw of the upper bracket holding the door to the frame.
5. Loosen the inner screw of the upper bracket and slide the door and bracket to let
the screw pass through the bracket.
6. Tilt the door away from the cabinet and lift it off the bottom bracket.
7.
Remove the bottom bracket.
Top Cover Removal
1. The top cover is held in place by plastic tabs at the front and back of the cover.
Push the cover up to release the tabs and lift it off the cabinet.
Top Cover Replacement
1. Replace the cover after you have replaced the side panels. Covers are different for
each cabinet. Place the correct cover on the correct cabinet and snap in place.
Side Panel Removal
1. The side panels are held in place by two screws toward the bottom of the panel at
the front and at the rear of the cabinet. Loosen both screws.
2.
Pull the bottom of the panel free from the side members of the frame and lift it off
the top frame member.
Side Panel Replacement
1.
Reverse the removal procedure.
Door Replacement
1.
Replace the doors after you have replaced the side panels and covers.
2.
Reverse the removal procedure.