HP 41802A, Operation Note, Page: 22 / 50

Operating Check Using a Network Analyzer
Using an HP 8751A or HP 3577A/B Network Analyzer
This section provides the HP 41802A operating check procedure using the HP 8751A or the HP
3577A/B network analyzer .
Equipment Required.
Network Analyzer: HP 8751A or HP 3577A/B
BNC(m)-BNC(m) Cable , 30 cm: PN 8120-1838
A dapters: as necessary
Procedure .
1. Connect the equipment as shown in Figure 3-1. Note that the probe power plug must be
connected before connecting the HP 41802A's N-type connector .
Figure 3-1. Operating Check Setup Using HP 8751A or HP 3577A/B Network Analyzer
2. Set the network analyzer as follows:
Measurement Mode: B(, A, or R) (absolute amplitude measurement)
Center Frequency: 1 MHz
Frequency Span: 0 Hz
Output Level: 010 dBm
3. Conrm that the signal level is `04 dB 6 5 dB .'
Note
If the signal level is lower than the limit, conrm that the power trip function
is set to OFF .
3-4 Operation