value
: Additional metric of sent routes, in the range of 1 to 16.
Description
Use
rip metricout
to add a metric to sent routes.
Use
undo rip metricout
to restore the default.
By default, the additional metric for sent routes is 1.
With the command configured on an interface, the metric of RIP routes sent on the interface will be
increased.
If a routing policy is referenced with the
route-policy
keyword, the following operations can be
performed:
•
Routes matching the policy is added with the metric specified in the
apply cost
command
configured in the policy. Routes not matching it is added with the metric specified in the
rip
metricout
command. The
rip metricout
command does not support the
+
or – keyword—used
to add or reduce a metric—specified in the
apply cost
command. For more information about
the
apply cost
command, see "
Routing policy configuration commands
•
If the
apply cost
command is not configured in the policy, all the advertised routes is added with
the metric specified in the
rip metricout
command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 for the outgoing route 1.0.0.0/8 and to add a
metric of 2 for other outgoing routes.
<Sysname> system-view
[Sysname] ip ip-prefix 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy] if-match ip-prefix 123
[Sysname-route-policy] apply cost 6
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricout route-policy abc 2
rip mib-binding
Syntax
rip mib-binding
process-id
undo rip mib-binding
View
System view
Default level
2: System level
Parameters
process-id
: RIP process ID, in the range of 1 to 65535.
Description
Use
rip mib-binding
to bind MIB operations with a specified RIP process, so that the RIP process
can receive SNMP requests.
Use
undo rip mib-binding
to restore the default.
By default, MIB operations are bound to RIP process 1. RIP process 1 is enabled to receive SNMP
requests.
51
