Routing policy configuration commands
The common routing policy configuration commands are applicable to both IPv4 and IPv6.
HPE FlexNetwork 3600 v2 SI Switch Series does not support OSPF, BGP, IS-IS, OSPFv3, IPv6 BGP,
or IPv6 IS-IS.
Common routing policy configuration commands
apply as-path
Syntax
apply as-path as-number
&<1-10>
[
replace
]
undo apply as-path
View
Routing policy view
Default level
2: System level
Parameters
as-number
&<1-10>: AS number, in the range of 1 to 4294967295. &<1-10>: Indicates you can enter
up to 10 AS numbers.
replace
: Replaces the original AS numbers.
Description
Use
apply as-path
to apply the specified AS numbers to BGP routes.
Use
undo apply as-path
to remove the clause configuration.
No AS_PATH attribute is set by default.
With the
replace
keyword included, the
apply as-path
command replaces the original AS_PATH
attribute with the specified AS numbers. Without the
replace
keyword, this command adds the
specified AS numbers before the original AS_PATH attribute.
Examples
# Configure node 10 in permit mode of routing policy
policy1
: add AS number 200 before the original
AS_PATH attribute of BGP routing information matching AS path list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply as-path 200
apply comm-list delete
Syntax
apply comm-list
{
comm-list-number
|
comm-list-name
}
delete
undo apply comm-list
409
